4 Inch Tri-clamp Pressure Lid with 2 Inch Tri-clamp Port

Get a better RAPT Pill WiFi reading with the all new Kegmenter Lid from KegLand.

Suits any standard 4 Inch Tri-Clover Ferrule.

Reinforced Industrial Plastic 4 Inch TC pressure lid with 2 Inch TC port. Suits a 35psi RED Pressure relief valve and two carbonation caps.

You can also fit a temp twister and 600mm thermowell probe into it.

Due to the large 4 Inch Tri-Clover diameter, it is difficult to get higher pressures without leaking.

Therefore we suggest using this up to 1.5 BAR (21psi)

This should only be used with a Red 35psi PRV (Pressure Relief Valve) or the Yellow 17psi PRV

1 x KL05333 Red 35psi PRV or 1 x KL22569 Yellow 17psi PRV

We would also recommend the following extras if you do not have them already:
1 x KL10788 – RED Multi Gas Post Plastic Carbonation Cap
1 x KL10788-Yellow – YELLOW Multi Liquid Post Plastic Carbonation Cap
1 x KL04602 – 4 Inch TC Clamp Beaded Seal
1 x KL32902 – 4 Inch TC 3 Segment Clamp
1 x KL03438 – 2 Inch TC Clamp Beaded Seal
1 x KL03322 – 2 Inch TC 2 Segment Clamp
1 x KL27564 – 2 Inch x 2 Inch Butterfly Valve
1 x KL23627 – PCO1881 Male x 2 Inch Tri-Clover (POK)
1 x KL26079 – 2 Inch Hop Bong
1 x KL20176 PCO1881 PRV Cap (for hop bong)
Extra 1 x KL05333 Red 35psi PRV (for hop bong)
Extra KL10788 RED Multi Gas Post Plastic Carbonation Cap (for hop bong)
Extra KL03322 2 Inch TC 2 Segment Clamp (for hop bong)
Extra KL03438 – 2 Inch TC Clamp Beaded Seal (for hop bong)